Search filters

List of works by Jorge Salguero

Analysis of Secondary Adhesion Wear Mechanism on Hard Machining of Titanium Aerospace Alloy

scientific article published on 23 June 2019

Application of Pin-On-Disc Techniques for the Study of Tribological Interferences in the Dry Machining of A92024-T3 (Al⁻Cu) Alloys

scientific article published on 18 July 2018

Defect Analysis and Detection of Cutting Regions in CFRP Machining Using AWJM

scientific article published on 05 December 2019

Evaluation of the Joining Response of Biodegradable Polylactic Acid (PLA) from Fused Deposition Modeling by Infrared Laser Irradiation

scientific article published on 26 October 2020

Experimental Parametric Model for Adhesion Wear Measurements in the Dry Turning of an AA2024 Alloy

scientific article published on 03 September 2018

Influence of Abrasive Waterjet Parameters on the Cutting and Drilling of CFRP/UNS A97075 and UNS A97075/CFRP Stacks

scientific article published on 30 December 2018

Influence of PLA Filament Conditions on Characteristics of FDM Parts

scientific article published on 31 July 2018

Kerf Taper Defect Minimization Based on Abrasive Waterjet Machining of Low Thickness Thermoplastic Carbon Fiber Composites C/TPU

scientific article published on 13 December 2019

On the Machinability of an Al-63%SiC Metal Matrix Composite

scientific article published on 06 March 2020

Three-dimensional chemical mapping using non-destructive SEM and photogrammetry

scientific article published on 20 July 2018

Tool Wear Mechanism in Cutting of Stack CFRP/UNS A97075.

scientific article published on 25 July 2018

Paulina is supported by:

About Paulina

Help