Search filters

List of works by Thomas Klünsner

Cyclic heat-up and damage-relevant substrate plastification of single- and bilayer coated milling inserts evaluated numerically

scientific article published in February 2019

Effect of shot peening on residual stresses and crack closure in CVD coated hard metal cutting inserts

scientific article published in August 2019

Experimentally validated calculation of the cutting edge temperature during dry milling of Ti6Al4V

scientific article published in April 2020

FE temperature- and residual stress prediction in milling inserts and correlation with experimentally observed damage mechanisms

scientific article published in June 2018

Fatigue behaviour of WC-Co hard metal under stress ratio and effectively loaded volume relevant to metalworking tool failure

Fatigue life equality of polished and electrical discharge machined WC-Co hard metal achieved solely by wet blasting

scientific article published in September 2016

Finite element study of the influence of hard coatings on hard metal tool loading during milling

scientific article published in October 2016

Influence of WC-Co hard metal microstructure on defect density, initiation and propagation kinetics of fatigue cracks starting at intrinsic and artificial defects under a negative stress ratio

Influence of surface topography on early stages on steel galling of coated WC-Co hard metals

scientific article published in June 2016

Morphology characterization and friction coefficient determination of sputtered V2O5 films

Shot peening-induced plastic deformation of individual phases within a coated WC-Co hard metal composite material including stress-strain curves for WC as a function of temperature

scientific article published in December 2019

Synthesis–structure relations for reactive magnetron sputtered V2O5 films

Paulina is supported by:

About Paulina

Help