List of works - Jordina Fornell

A CaCO3/nanocellulose-based bioinspired nacre-like material

scientific article published in 2017

Anodic formation of self-organized Ti(Nb,Sn) oxide nanotube arrays with tuneable aspect ratio and size distribution

scientific article published in August 2013

Biodegradable FeMnSi Sputter-Coated Macroporous Polypropylene Membranes for the Sustained Release of Drugs

scientific article

Codeposition of inorganic fullerene-like WS2 nanoparticles in an electrodeposited nickel matrix under the influence of ultrasonic agitation

scholarly article by E. García-Lecina et al published December 2013 in Electrochimica Acta

Corrigendum to “Mapping of mechanical and magnetic properties of Fe-W alloys electrodeposited from Fe(III)-based glycolate-citrate bath” [Mater. Des. 139 (2018) 429–438]

scholarly article published in Materials & Design

Deformation and fracture behavior of corrosion-resistant, potentially biocompatible, Ti40Zr10Cu38Pd12 bulk metallic glass

Effects of shot peening on the nanoindentation response of Cu47.5Zr47.5Al5 metallic glass

scientific article published in February 2014

Electrochemical Synthesis of Bismuth Particles: Tuning Particle Shape through Substrate Type within a Narrow Potential Window

scientific article published on 6 January 2017

Enhanced mechanical properties and in vitro corrosion behavior of amorphous and devitrified Ti40Zr10Cu38Pd12 metallic glass

scientific article published on 27 May 2011

Enhanced mechanical properties and microstructural modifications in electrodeposited Fe-W alloys through controlled heat treatments

Enhanced mechanical properties due to structural changes induced by devitrification in Fe–Co–B–Si–Nb bulk metallic glass

scientific article published in November 2010

Enhanced mechanical properties in a Zr-based metallic glass caused by deformation-induced nanocrystallization

scientific article published in January 2010

Evolution of the Mechanical Properties of Ti-Based Metallic Glass During Depth-Sensing Load–Unload Nanoindentation Cycles

scientific article published in December 2010

Ferromagnetic-like behaviour in bismuth ferrite films prepared by electrodeposition and subsequent heat treatment

scholarly article in RSC Advances, vol. 7 no. 51, 2017

Improved mechanical performance and delayed corrosion phenomena in biodegradable Mg-Zn-Ca alloys through Pd-alloying.

scientific article published on 4 November 2011

Improved plasticity and corrosion behavior in Ti–Zr–Cu–Pd metallic glass with minor additions of Nb: An alloy composition intended for biomedical applications

article

Indentation plastic work and large compression plasticity in in situ nanocrystallized Zr62Cu18Ni10Al10 bulk metallic glass

scientific article published in June 2011

Influence of the Si content on the microstructure and mechanical properties of Ti–Ni–Cu–Si–Sn nanocomposite alloys

scientific article published in September 2012

Influence of the irradiation temperature on the surface structure and physical/chemical properties of Ar ion-irradiated bulk metallic glasses

Influence of the loading rate on the indentation response of Ti-based metallic glass

scientific article published in March 2009

Influence of the shot-peening intensity on the structure and near-surface mechanical properties of Ti40Zr10Cu38Pd12 bulk metallic glass

Large Magnetoelectric Effects in Electrodeposited Nanoporous Microdisks Driven by Effective Surface Charging and Magneto-Ionics

scientific article published on 17 December 2018

Mapping of magnetic and mechanical properties of Fe-W alloys electrodeposited from Fe(III)-based glycolate-citrate bath

Mechanical behavior under nanoindentation of a new Ni-based glassy alloy produced by melt-spinning and copper mold casting

scientific article published in September 2010

Mechanical behaviour of brushite and hydroxyapatite coatings electrodeposited on newly developed FeMnSiPd alloys

Mechanical properties, corrosion performance and cell viability studies on newly developed porous Fe-Mn-Si-Pd alloys

Mesoporous Oxide-Diluted Magnetic Semiconductors Prepared by Co Implantation in Nanocast 3D-Ordered In2O3–y Materials

scientific article published on 8 August 2013

Nanoindentation response of Cu–Ti based metallic glasses: Comparison between as-cast, relaxed and devitrified states

scientific article published in October 2015

Nanomechanical behaviour of open-cell nanoporous metals: Homogeneous versus thickness-dependent porosity

Nanostructured Ti-Zr-Pd-Si-(Nb) bulk metallic composites: Novel biocompatible materials with superior mechanical strength and elastic recovery.

scientific article published on December 2014

Nanostructured β-phase Ti–31.0Fe–9.0Sn and sub-μm structured Ti–39.3Nb–13.3Zr–10.7Ta alloys for biomedical applications: Microstructure benefits on the mechanical and corrosion performances

Novel Fe–Mn–Si–Pd alloys: insights into mechanical, magnetic, corrosion resistance and biocompatibility performances

scientific article published on 21 September 2016

Novel Ti-Zr-Hf-Fe Nanostructured Alloy for Biomedical Applications

scientific article published on 25 October 2013

Single step electrosynthesis of NiMnGa alloys

article by Berna Özkale et al published June 2016 in Electrochimica Acta

Spontaneous formation of spiral-like patterns with distinct periodic physical properties by confined electrodeposition of Co-In disks

scientific article published on 27 July 2016

Structural and mechanical modifications induced on Cu47.5Zr47.5Al5 metallic glass by surface laser treatments

Synthesis of α-Fe₂O₃ and Fe-Mn Oxide Foams with Highly Tunable Magnetic Properties by the Replication Method from Polyurethane Templates.

scientific article published on 11 February 2018

The Influence of Deformation-Induced Martensitic Transformations on the Mechanical Properties of Nanocomposite Cu-Zr-(Al) Systems

scientific article published on 16 November 2010

Tunable Magnetism in Nanoporous CuNi Alloys by Reversible Voltage-Driven Element-Selective Redox Processes

scientific article published on 18 April 2018

Unconventional elastic properties, deformation behavior and fracture characteristics of newly developed rare earth bulk metallic glasses

scientific article published in December 2009

Work-hardening mechanisms of the Ti60Cu14Ni12Sn4Nb10 nanocomposite alloy

scientific article published in October 2009

Yielding and intrinsic plasticity of Ti–Zr–Ni–Cu–Be bulk metallic glass

scientific article published in August 2009

List of works by Jordina Fornell