Search filters

List of works by David Mba

A Comparative Study of the Effectiveness of Adaptive Filter Algorithms, Spectral Kurtosis and Linear Prediction in Detection of a Naturally Degraded Bearing in a Gearbox

scholarly article by Faris Elasha et al published 15 August 2014 in Journal of Failure Analysis and Prevention

A New Model for Estimating Vibrations Generated in the Defective Rolling Element Bearings

scholarly article by Mehdi Behzad et al published 11 April 2011 in Journal of Vibration and Acoustics

A benchmark of Canonical Variate Analysis for fault detection and diagnosis

A comparative experimental study on the diagnostic and prognostic capabilities of acoustics emission, vibration and spectrometric oil analysis for spur gears

scientific article published in 2007

A comparative experimental study on the use of acoustic emission and vibration analysis for bearing defect identification and estimation of defect size

article

A finite element-based algorithm for rubbing induced vibration prediction in rotors

scientific article

Accelerated natural fault diagnosis in slow speed bearings with Acoustic Emission

scholarly article by M. Elforjani & David Mba published January 2010 in Engineering Fracture Mechanics

Acoustic Emission and Gas-Phase Measurements in Two-Phase Flow

Acoustic Emission and Specific Film Thickness for Operating Spur Gears

scientific article published in April 2007

Acoustic emission and specific film thickness (λ) for spur gears

scholarly article by R I Raja Hamzah & David Mba published November 2008 in Insight

Acoustic emission during run-up and run-down of a power generation turbine

scientific article published in May 2004

Acoustic emission signals associated with damaged helical gears

scholarly article by B Eftekharnejad & David Mba published August 2008 in Insight

Acoustic emission technology for detection of shaft-to-seal rubbing on power generation turbines; a qualitative verification

scientific article published in December 2006

Acoustic emissions diagnosis of rotor-stator rubs using the KS statistic

scientific article published in July 2004

Acoustic frequency for bubble size correlation using acoustic emissions

An initial investigation on the potential applicability of Acoustic Emission to rail track fault detection

scientific article published in October 2004

Applicability of acoustic emissions to monitoring the mechanical integrity of bolted structures in low speed rotating machinery: case study

scientific article published in July 2002

Application of acoustic emission technology for detecting the onset and duration of contact in liquid lubricated mechanical seals

scientific article published in August 2006

Application of acoustic emission to seeded gear fault detection

scientific article published in 2005

Assessment of natural crack initiation and its propagation in slow speed bearings

scholarly article by M. Elforjani & David Mba published September 2009 in Nondestructive Testing and Evaluation

Assessment of the application of acoustic emission technology for monitoring the presence of sand under multiphase flow condition

Bearing Natural Degradation Detection in a Gearbox: A Comparative Study of the Effectiveness of Adaptive Filter Algorithms and Spectral Kurtosis

Bearing Replacement Interval Extension for Helicopters

Bearing defect diagnosis and acoustic emission

scientific article published in April 2003

Bearing replacement extension without failure data

Bearing time-to-failure estimation using spectral analysis features

Challenges and obstacles in the application of acoustic emission to process machinery

Condition Monitoring of Slow-Speed Shafts and Bearings with Acoustic Emission

scholarly article by M. Elforjani & David Mba published 19 August 2010 in Strain

Condition monitoring of worm gears

Correlation Between Acoustic Emission Activity and Asperity Contact During Meshing of Spur Gears Under Partial Elastohydrodynamic Lubrication

scientific article published in September 2005

Cyclostationarity of Acoustic Emissions (AE) for monitoring bearing defects

scholarly article by B. Kilundu et al published August 2011 in Mechanical Systems and Signal Processing

Defect size estimation in rolling element bearings using vibration time waveform

scholarly article by M Behzad et al published August 2009 in Insight

Detecting Shaft-to-Seal Rubbing in Power Generation Turbines With the Acoustic Emission Technology

scientific article

Detecting natural crack initiation and growth in slow speed shafts with the Acoustic Emission technology

Detecting the onset, propagation and location of non-artificial defects in a slow rotating thrust bearing with acoustic emission

scholarly article by M Elforjani & David Mba published May 2008 in Insight

Detection of incipient cavitation and determination of the best efficiency point for centrifugal pumps using acoustic emission

scientific article published in November 2005

Detection of machine soft foot with vibration analysis

article by F Elasha et al published 1 November 2014 in Insight

Detection of shaft-seal rubbing in large-scale power generation turbines with acoustic emissions. Case study

scientific article published in 2004

Development of Acoustic Emission Technology for Condition Monitoring and Diagnosis of Rotating Machines: Bearings, Pumps, Gearboxes, Engines, and Rotating Structures

article

Development of a thick film PZT foil sensor for use in structural health monitoring applications

scientific article published in February 2013

Diagnosis and Prognosis of AH64D Tail Rotor Gearbox Bearing Degradation

Diagnosis of continuous rotor–stator rubbing in large scale turbine units using acoustic emissions

scientific article published in March 2004

Diagnostics and prognostics using switching Kalman filters

Diagnostics and prognostics with acoustic emission, vibration and spectrometric oil analysis for spur gears ? a comparative study

scientific article published in August 2005

Effect of the Denoising on Acoustic Emission Signals

scholarly article by X. Chiementin et al published 28 April 2010 in Journal of Vibration and Acoustics

Effectiveness of Adaptive Filter Algorithms and Spectral Kurtosis in Bearing Faults Detection in a Gearbox

article published in 2014

Elastohydrodynamic Film Thickness and Acoustic Emission for Meshing of Spur and Helical Gears

article published in 2007

Energy Index technique for detection of Acoustic Emissions associated with incipient bearing failures

Ensuring effluent standards by improving the design of Rotating Biological Contactors

scientific article published in April 2007

Estimating bearing lower bound reliability without past failures

article by Reuben Lim Chi Keong & David Mba published 14 January 2013 in Proceedings of the Institution of Mechanical Engineers, Part O: Journal of Risk and Reliability

Estimation of bearing defect size with acoustic emission

scientific article published in December 2004

Experimental Investigation of the Influence of Fouling on Compressor Cascade Characteristics and Implications for Gas Turbine Engine Performance

Experimental investigation into the capabilities of acoustic emission for the detection of shaft-to-seal rubbing in large power generation turbines: A case study

scientific article published in July 2006

Experimentally Established Correlation between Acoustic Emission Activity, Load, Speed, and Asperity Contact of Spur Gears Under Partial Elastohydrodynamic Lubrication

scientific article published in June 2005

Feasibility study on the use of the Acoustic Emission technology for monitoring flow patterns in two phase flow

Gas Void Fraction Measurement in Two-Phase Gas/Liquid Slug Flow Using Acoustic Emission Technology

scholarly article by S. Al-lababidi et al published 18 November 2009 in Journal of Vibration and Acoustics

High-frequency acoustic emission and single gas bubble burst

Identification of minimum transport condition for sand in two-phase flow using acoustic emission technology

Identification of the acoustic emission source during a comparative study on diagnosis of a spur gearbox

scientific article published in May 2005

Improved condition monitoring using fast-oscillating measurements

Influence of operational variables in a hydrodynamic bearing on the generation of acoustic emission

scholarly article by S.A. Mirhadizadeh et al published September 2010 in Tribology International

Investigating the Capability of Acoustic Emission Technology to Determine Slug Velocity in Gas/Water Two Phase Flow in Horizontal Pipes

Investigation of the Synchronous Response in a Back-Back Centrifugal Compressor Due to Imbalance and Seal Distortion

Investigation of the influence of oil film thickness on helical gear defect detection using Acoustic Emission

Investigation on Sand Particle Impingement on Steel Pipe in Two Phase Flow Using Acoustic Emission Technology

Limitation of Acoustic Emission for Identifying Seeded Defects in Gearboxes

scientific article published in March 2005

Mechanical evolution of the rotating biological contactor into the 21st century

scientific article published in August 2003

Mechanical redesign of the rotating biological contactor

scientific article published in December 1999

Monitoring Natural Pitting Progress on Helical Gear Mesh Using Acoustic Emission and Vibration

scholarly article by B. Eftekharnejad & David Mba published 5 July 2010 in Strain

Monitoring extremely slow rolling element bearings: part I

scientific article published in September 2002

Monitoring extremely slow rolling element bearings: part II

scientific article published in September 2002

Monitoring oil film regimes with acoustic emission

Monitoring sand particle concentration in two-phase flow using acoustic emission

Monitoring the Onset and Propagation of Natural Degradation Process in a Slow Speed Rolling Element Bearing With Acoustic Emission

scholarly article by M. Elforjani & David Mba published 15 July 2008 in Journal of Vibration and Acoustics

Monitoring the lubricant condition in a low-speed rolling element bearing using high frequency stress waves

scientific article published in May 2002

Monitoring the presence of water and water–sand droplets in a horizontal pipe with Acoustic Emission technology

Natural mechanical degradation measurements in slow speed bearings

Non-linearity in experimental journal bearing dynamics - a new approach

Observation of acoustic emission from gas bubble inception and burst

Observations and Location of Acoustic Emissions for a Naturally Degrading Rolling Element Thrust Bearing

scholarly article by Mohamed Elforjani & David Mba published 3 May 2008 in Journal of Failure Analysis and Prevention

Observations of Acoustic Emission Under Conditions of Varying Specific Film Thickness for Meshing Spur and Helical Gears

scholarly article by R. I. Raja Hamzah et al published 1 April 2008 in Journal of Tribology

Observations of a naturally degrading slow-speed shaft

scholarly article by M. Elforjani et al published December 2010 in Nondestructive Testing and Evaluation

Observations of acoustic emission activity during gear defect diagnosis

scientific article published in October 2003

Observations of acoustic emission in a hydrodynamic bearing

Observations of changes in acoustic emission waveform for varying seeded defect sizes in a rolling element bearing

Operational Bearing Parameters and Acoustic Emission Generation

scholarly article by J. Couturier & David Mba published 30 January 2008 in Journal of Vibration and Acoustics

Pitting Detection in Worm Gearboxes with Vibration Analysis

Pitting detection in worm gearboxes with vibration analysis

Prognosis of a Wind Turbine Gearbox Bearing Using Supervised Machine Learning

scientific article published on 12 July 2019

Reliability model for helicopter main gearbox lubrication system using influence diagrams

Rolling bearing fault detection by short-time statistical features

Rotor dynamic response of a centrifugal compressor due to liquid carry over: A case study

Seeded fault detection on helical gears with acoustic emission

Sensitivity of acoustic emission (AE) technology in monitoring oxide formation on an aluminium surface

scholarly article by S Husin et al published 1 December 2011 in Insight

Shaft crack diagnostics in a gearbox

Spectral kurtosis applied to acoustic emission in bearings

Study of the application of Acoustic Emission technology for on-line monitoring of bubble phenomena and flow patterns in two-phase gas-liquid flow

Switching Kalman filter for failure prognostic

scholarly article by Chi Keong Reuben Lim & David Mba published February 2015 in Mechanical Systems and Signal Processing

The Use of Acoustic Emission for Estimation of Bearing Defect Size

scholarly article by David Mba published 5 March 2008 in Journal of Failure Analysis and Prevention

The application of acoustic emission for detecting incipient cavitation and the best efficiency point of a 60kW centrifugal pump: case study

scientific article published in July 2005

The application of spectral kurtosis on Acoustic Emission and vibrations from a defective bearing

scholarly article by B. Eftekharnejad et al published January 2011 in Mechanical Systems and Signal Processing

The environment, international standards, asset health management and condition monitoring: An integrated strategy

The influence of operating condition on acoustic emission (AE) generation during meshing of helical and spur gear

scholarly article by R.I. Raja Hamzah & David Mba published January 2009 in Tribology International

The transmission of acoustic emission across large-scale turbine rotors

scientific article published in December 2002

Use of Spectral Kurtosis for Improving Signal to Noise Ratio of Acoustic Emission Signal from Defective Bearings

scholarly article by C. Ruiz-Cárcel et al published 20 March 2014 in Journal of Failure Analysis and Prevention

ZnO surface modified PZT for enhanced ceramic composite thick film sensors

journal article; published in Advances in Applied Ceramics in 2013