List of works - Sandra Korte-Kerzel

A rare-earth free magnesium alloy with improved intrinsic ductility

scientific article

Analysis of microstructure formation in cast Zn alloys derived from computational thermodynamics of the Zn–Al–Cu–Mg system

scientific article published on 29 March 2019

Anomalous yielding in the complex metallic alloy Al13Co4

Atomistic simulations of basal dislocations in Mg interacting with Mg17Al12 precipitates

scientific article published in September 2019

Composition and cooling-rate dependence of plastic deformation, densification, and cracking in sodium borosilicate glasses during pyramidal indentation

scientific article published in July 2015

Damage Analysis in Dual-Phase Steel Using Deep Learning: Transfer from Uniaxial to Biaxial Straining Conditions by Image Data Augmentation

scientific article published on 16 October 2020

Data on measurement of the strain partitioning in a multiphase Zn-Al eutectic alloy

scientific article published on 08 September 2018

Deformation in the γ-Mg17Al12 phase at 25–278 °C

scientific article published in July 2016

Deformation of silicon – Insights from microcompression testing at 25–500°C

Deformation of µm- and mm-sized Fe2.4wt%Si single- and bi-crystals with a high angle grain boundary at room temperature

scientific article published in August 2020

Discontinuous yield in InGaAs thin films

scientific article published in December 2008

Discussion of the dependence of the effect of size on the yield stress in hard materials studied by microcompression of MgO

Dislocation interaction and twinning-induced plasticity in face-centered cubic Fe-Mn-C micro-pillars

scientific article published in June 2017

Dislocations and Plastic Deformation in MgO Crystals: A Review

Effect of the Interdependence of Cold Rolling Strategies and Subsequent Punching on Magnetic Properties of NO Steel Sheets

scientific article published in May 2016

Elastic and plastic properties of InxGa1−xAs

scientific article published on 25 September 2008

Eliminating deformation incompatibility in composites by gradient nanolayer architectures

scientific article published in Scientific Reports

Finding and Characterising Active Slip Systems: A Short Review and Tutorial with Automation Tools

scientific article published on 15 January 2021

From quantum to continuum mechanics: studying the fracture toughness of transition metal nitrides and oxynitrides

scientific article published on 17 December 2017

Global and High-Resolution Damage Quantification in Dual-Phase Steel Bending Samples with Varying Stress States

scientific article published on 12 March 2019

Impact of the interaction of material production and mechanical processing on the magnetic properties of non-oriented electrical steel

scientific article published in April 2018

Influence of Cooling Rate on Cracking and Plastic Deformation during Impact and Indentation of Borosilicate Glasses

article published in 2017

Influence of test temperature on the size effect in molybdenum small-scale compression pillars

scientific article published in June 2013

Intrinsic and extrinsic size effects in the deformation of amorphous CuZr/nanocrystalline Cu nanolaminates

Investigation of the deformation behavior of aluminum micropillars produced by focused ion beam machining using Ga and Xe ions

scientific article published in January 2017

Investigation of the electroplastic effect using nanoindentation

scientific article published in December 2019

Large-area, high-resolution characterisation and classification of damage mechanisms in dual-phase steel using deep learning

scientific article published on 08 May 2019

Local mechanical properties and plasticity mechanisms in a Zn-Al eutectic alloy

scholarly article by Zhicheng Wu et al published November 2018 in Materials & Design

Local mechanical properties of the (β0+ω0) composite in multiphase titanium aluminides studied with nanoindentation at room and high temperatures

scientific article published in May 2016

Low temperature deformation of MoSi2 and the effect of Ta, Nb and Al as alloying elements

scientific article published in December 2019

Manipulation of matter by electric and magnetic fields: Toward novel synthesis and processing routes of inorganic materials

scholarly article by Olivier Guillon et al published June 2018 in Materials Today

Mechanical behaviour of Zn–Al–Cu–Mg alloys: Deformation mechanisms of as-cast microstructures

scientific article published in January 2016

Mechanical characterisation of the protective Al2O3 scale in Cr2AlC MAX phases

scientific article published in December 2019

Microcompression of brittle and anisotropic crystals: recent advances and current challenges in studying plasticity in hard materials

scientific article published on 20 March 2017

Non-Newtonian Flow to the Theoretical Strength of Glasses via Impact Nanoindentation at Room Temperature.

scientific article published on 15 December 2017

Observations of flow in InxGa1-xAs multilayers

scientific article published in August 2008

On extracting mechanical properties from nanoindentation at temperatures up to 1000 °C

scientific article published in November 2017

On the effect of material processing: microstructural and magnetic properties of electrical steel sheets

scientific article published in September 2014

On the effect of precipitates on the cyclic deformation behavior of an Al–Mg–Si alloy

scientific article published on 11 September 2017

On the influence of the heat treatment on microstructure formation and mechanical properties of near-α Ti-Fe alloys

scholarly article by Stefanie Sandlöbes et al published March 2019 in Materials Science and Engineering A: Structural Materials: Properties, Microstructures and Processing

On the mechanical properties and deformation mechanisms of manganese sulphide inclusions

scientific article published in August 2020

On the structure of defects in the Fe7Mo6 μ-Phase

scientific article published in April 2019

On the twinning shear of{101¯2}twins in magnesium – Experimental determination and formal description

scientific article published in August 2017

Onset of plasticity in InxGa1−xAs multilayers

article by Sandra Korte-Kerzel & William Clegg published January 2010 in Acta Materialia

Precipitation and decomposition phenomena in a Zn-Al-Cu-Mg alloy

scientific article published in July 2016

Processing-Property Relationships of Hemp Fibre ⬇️

2006 master's thesis by Sandra Korte at University of Canterbury

Room temperature deformation in the Fe7Mo6 μ-Phase

scholarly article by S. Schröders et al published September 2018 in International Journal of Plasticity

Room temperature deformation of LPSO structures by non-basal slip

scientific article published in January 2017

Room temperature plasticity in m-Al13Co4 studied by microcompression and high resolution scanning transmission electron microscopy

article by Sandra Korte-Kerzel et al published March 2018 in Scripta Materialia

Softening non-metallic crystals by inhomogeneous elasticity

scientific article published on 14 September 2017

Texture Selection Mechanisms during Recrystallization and Grain Growth of a Magnesium-Erbium-Zinc Alloy

scientific article published on 19 January 2021

The effect of large plastic deformation on elevated temperature mechanical behavior of dynamic strain aging Al-Mg alloys

scientific article published in December 2019

The role of mesoscopic deformation heterogeneities in plastic flow and recrystallization of a magnesium sheet alloy

scientific article published in August 2020

Three-dimensional electron backscattered diffraction analysis of deformation in MgO micropillars

Ti and its alloys as examples of cryogenic focused ion beam milling of environmentally-sensitive materials

scientific article published on 26 February 2019

Twinning effects in deformed and annealed magnesium–neodymium alloys

scientific article published in October 2015

List of works by Sandra Korte-Kerzel

A rare-earth free magnesium alloy with improved intrinsic ductility

Analysis of microstructure formation in cast Zn alloys derived from computational thermodynamics of the Zn–Al–Cu–Mg system

Anomalous yielding in the complex metallic alloy Al13Co4

Atomistic simulations of basal dislocations in Mg interacting with Mg17Al12 precipitates

Composition and cooling-rate dependence of plastic deformation, densification, and cracking in sodium borosilicate glasses during pyramidal indentation

Damage Analysis in Dual-Phase Steel Using Deep Learning: Transfer from Uniaxial to Biaxial Straining Conditions by Image Data Augmentation

Data on measurement of the strain partitioning in a multiphase Zn-Al eutectic alloy

Deformation in the γ-Mg17Al12 phase at 25–278 °C

Deformation of silicon – Insights from microcompression testing at 25–500°C

Deformation of µm- and mm-sized Fe2.4wt%Si single- and bi-crystals with a high angle grain boundary at room temperature

Discontinuous yield in InGaAs thin films

Discussion of the dependence of the effect of size on the yield stress in hard materials studied by microcompression of MgO

Dislocation interaction and twinning-induced plasticity in face-centered cubic Fe-Mn-C micro-pillars

Dislocations and Plastic Deformation in MgO Crystals: A Review

Effect of the Interdependence of Cold Rolling Strategies and Subsequent Punching on Magnetic Properties of NO Steel Sheets

Elastic and plastic properties of InxGa1−xAs

Eliminating deformation incompatibility in composites by gradient nanolayer architectures

Finding and Characterising Active Slip Systems: A Short Review and Tutorial with Automation Tools

From quantum to continuum mechanics: studying the fracture toughness of transition metal nitrides and oxynitrides

Global and High-Resolution Damage Quantification in Dual-Phase Steel Bending Samples with Varying Stress States

Impact of the interaction of material production and mechanical processing on the magnetic properties of non-oriented electrical steel

Influence of Cooling Rate on Cracking and Plastic Deformation during Impact and Indentation of Borosilicate Glasses

Influence of test temperature on the size effect in molybdenum small-scale compression pillars

Intrinsic and extrinsic size effects in the deformation of amorphous CuZr/nanocrystalline Cu nanolaminates

Investigation of the deformation behavior of aluminum micropillars produced by focused ion beam machining using Ga and Xe ions

Investigation of the electroplastic effect using nanoindentation

Large-area, high-resolution characterisation and classification of damage mechanisms in dual-phase steel using deep learning

Local mechanical properties and plasticity mechanisms in a Zn-Al eutectic alloy

Local mechanical properties of the (β0+ω0) composite in multiphase titanium aluminides studied with nanoindentation at room and high temperatures

Low temperature deformation of MoSi2 and the effect of Ta, Nb and Al as alloying elements

Manipulation of matter by electric and magnetic fields: Toward novel synthesis and processing routes of inorganic materials

Mechanical behaviour of Zn–Al–Cu–Mg alloys: Deformation mechanisms of as-cast microstructures

Mechanical characterisation of the protective Al2O3 scale in Cr2AlC MAX phases

Microcompression of brittle and anisotropic crystals: recent advances and current challenges in studying plasticity in hard materials

Non-Newtonian Flow to the Theoretical Strength of Glasses via Impact Nanoindentation at Room Temperature.

Observations of flow in InxGa1-xAs multilayers

On extracting mechanical properties from nanoindentation at temperatures up to 1000 °C

On the effect of material processing: microstructural and magnetic properties of electrical steel sheets

On the effect of precipitates on the cyclic deformation behavior of an Al–Mg–Si alloy

On the influence of the heat treatment on microstructure formation and mechanical properties of near-α Ti-Fe alloys

On the mechanical properties and deformation mechanisms of manganese sulphide inclusions

On the structure of defects in the Fe7Mo6 μ-Phase

On the twinning shear of{101¯2}twins in magnesium – Experimental determination and formal description

Onset of plasticity in InxGa1−xAs multilayers

Precipitation and decomposition phenomena in a Zn-Al-Cu-Mg alloy

Processing-Property Relationships of Hemp Fibre ⬇️

Room temperature deformation in the Fe7Mo6 μ-Phase

Room temperature deformation of LPSO structures by non-basal slip

Room temperature plasticity in m-Al13Co4 studied by microcompression and high resolution scanning transmission electron microscopy

Softening non-metallic crystals by inhomogeneous elasticity

Texture Selection Mechanisms during Recrystallization and Grain Growth of a Magnesium-Erbium-Zinc Alloy

The effect of large plastic deformation on elevated temperature mechanical behavior of dynamic strain aging Al-Mg alloys

The role of mesoscopic deformation heterogeneities in plastic flow and recrystallization of a magnesium sheet alloy

Three-dimensional electron backscattered diffraction analysis of deformation in MgO micropillars

Ti and its alloys as examples of cryogenic focused ion beam milling of environmentally-sensitive materials

Twinning effects in deformed and annealed magnesium–neodymium alloys