Assessment of Compressive Behavior of Concrete Masonry Prisms Partially Filled by General Mortar

Assessment of the Flexural Behavior of Concrete Block Masonry Beams

Compressive Behavior of Granite: Experimental Approach

Evaluation of the performance of recycled textile fibres in the mechanical behaviour of a gypsum and cork composite material

article by Graça Vasconcelos et al published April 2015 in Cement and Concrete Composites

Experimental Analysis of Reinforced Concrete Block Masonry Walls Subjected to In-Plane Cyclic Loading

Experimental analysis of reinforced concrete block masonry spandrels using pre-fabricated planar trussed bars

Experimental characterization of stone masonry in shear and compression

Experimental characterization of the tensile behaviour of granites

scientific article published in 2008

Experimental investigation on the seismic performance of masonry buildings using shaking table testing

article by Paulo B. Lourenco et al published 29 December 2012 in Bulletin of Earthquake Engineering

Experimental seismic performance assessment of asymmetric masonry buildings

In-Plane Experimental Behavior of Stone Masonry Walls under Cyclic Loading

article

In-plane behavior of cavity masonry infills and strengthening with textile reinforced mortar

article by Farhad Akhoundi et al published February 2018 in Engineering Structures

In-plane shear behaviour of traditional timber walls

Influence of aggregates grading and water/cement ratio in workability and hardened properties of mortars

Influence of the Freeze-Thaw Cycles on the Physical and Mechanical Properties of Granites

Influence of the Geometry of Units and of the Filling of Vertical Joints in the Compressive and Tensile Strength of Masonry

Mode I Fracture Surface of Granite: Measurements and Correlations with Mechanical Properties

article published in 2008

Morphological and Geometrical Characterization of Historical Churches of Yucatan, Mexico

scientific article published in 2021

Numerical analysis of concrete block masonry beams under three point bending

Numerical modelling of non-confined and confined masonry walls

Numerically based proposals for the stiffness and strength of masonry infills with openings in reinforced concrete frames

Parametrical study of masonry walls subjected to in-plane loading through numerical modeling

Proposal of a Design Model for Masonry Walls Subjected to In-Plane Loading

Proposal of an innovative solution for partition walls: Mechanical, thermal and acoustic validation

The design and mechanical performance of high-performance perforated fired masonry bricks

article

Traditional earthquake resistant techniques for vernacular architecture and local seismic cultures: A literature review

article

Vertically perforated clay brick masonry for loadbearing and non-loadbearing masonry walls

article published in 2010