Search filters

List of works by Maureen van Eijnatten

3D assessment of damaged bicycle helmets and corresponding craniomaxillo-mandibular skull injuries: A feasibility study

scientific article published on 29 September 2017

3D deformable registration of longitudinal abdominopelvic CT images using unsupervised deep learning

scientific article published on 08 July 2021

A Novel Method of Orbital Floor Reconstruction Using Virtual Planning, 3-Dimensional Printing, and Autologous Bone.

scientific article published on 7 April 2016

Accuracy of MDCT and CBCT in three-dimensional evaluation of the oropharynx morphology.

scientific article published on 27 April 2017

CT image segmentation methods for bone used in medical additive manufacturing.

scientific article published on 30 October 2017

CT image segmentation of bone for medical additive manufacturing using a convolutional neural network

scientific article published on 16 October 2018

Effective Radiation Dose in the Wrist Resulting from a Radiographic Device, Two CBCT Devices and One MSCT Device: A Comparative Study

scientific article

Impact of prone, supine and oblique patient positioning on CBCT image quality, contrast-to-noise ratio and figure of merit value in the maxillofacial region.

scientific article published on 7 April 2017

MRI and Additive Manufacturing of Nasal Alar Constructs for Patient-specific Reconstruction.

scientific article published on 30 August 2017

Reliability and accuracy of three imaging software packages used for 3D analysis of the upper airway on cone beam computed tomography images

scientific article published on 3 May 2017

Segmentation of dental cone-beam CT scans affected by metal artifacts using a mixed-scale dense convolutional neural network

scientific article published on 13 September 2019

The accuracy of ultrashort echo time MRI sequences for medical additive manufacturing

scientific article published on 4 March 2016

The impact of manual threshold selection in medical additive manufacturing

scientific article published on 07 October 2016

Using 3D printing techniques to create an anthropomorphic thorax phantom for medical imaging purposes.

scientific article published in November 2017

Paulina is supported by:

About Paulina

Help