Search filters

List of works by Wolfgang Gindl-Altmutter

A General Aqueous Silanization Protocol to Introduce Vinyl, Mercapto or Azido Functionalities onto Cellulose Fibers and Nanocelluloses

scientific article published on 12 June 2018

Application of surface chemical functionalized cellulose nanocrystals to improve the performance of UF adhesives used in wood based composites - MDF type

scientific article published on 01 November 2018

Carbon Microparticles from Organosolv Lignin as Filler for Conducting Poly(Lactic Acid)

scientific article published on 26 May 2016

Cellulose nanofibrils as filler for adhesives: effect on specific fracture energy of solid wood-adhesive bonds

scientific article published on 15 July 2011

Comparison of UV and confocal Raman microscopy to measure the melamine–formaldehyde resin content within cell walls of impregnated spruce wood

Compatibility between cellulose and hydrophobic polymer provided by microfibrillated lignocellulose

scientific article published on 27 October 2014

Corrigendum to "Surface chemical functionalization of cellulose nanocrystals by 3-aminopropyltriethoxysilane"[Int. J. Biol. Macromol. 106 (2018) 1288-1296]

scientific article published on 28 March 2018

Effects of Fiber Angle on the Tensile Properties of Partially Delignified and Densified Wood

scientific article published on 27 November 2020

Electrically-Conductive Sub-Micron Carbon Particles from Lignin: Elucidation of Nanostructure and Use as Filler in Cellulose Nanopapers

scientific article published on 15 December 2018

Erratum

scholarly article published in Holzforschung

Evaluating fundamental position-dependent differences in wood cell wall adhesion using nanoindentation.

scientific article

Fine Cellulosic Materials Produced from Chemical Pulp: the Combined Effect of Morphology and Rate of Addition on Paper Properties

article

Impregnation of softwood cell walls with melamine-formaldehyde resin

scientific article

Lignocellulose Nanofiber-Reinforced Polystyrene Produced from Composite Microspheres Obtained in Suspension Polymerization Shows Superior Mechanical Performance

scientific article published on 17 May 2016

Microfibrillated Lignocellulose Enables the Suspension-Polymerisation of Unsaturated Polyester Resin for Novel Composite Applications.

scientific article

Nano meets the sheet: adhesive-free application of nanocellulosic suspensions in paper conservation

article

Nanopaper Properties and Adhesive Performance of Microfibrillated Cellulose from Different (Ligno-)Cellulosic Raw Materials

scientific article published on 31 July 2017

Particle Board and Oriented Strand Board Prepared with Nanocellulose-Reinforced Adhesive

Residual wood polymers facilitate compounding of microfibrillated cellulose with poly(lactic acid) for 3D printer filaments.

scientific article published in February 2018

Simple Green Route to Performance Improvement of Fully Bio-Based Linseed Oil Coating Using Nanofibrillated Cellulose

scientific article published on 07 September 2017

Suitability of Different Variants of Polyethylene Glycol Impregnation for the Dimensional Stabilization of Oak Wood

scientific article published on 16 January 2018

Surface chemical functionalization of cellulose nanocrystals by 3-aminopropyltriethoxysilane.

scientific article published on 27 August 2017

Synergy of multi-scale toughening and protective mechanisms at hierarchical branch-stem interfaces.

scientific article

The suitability of common reed (Phragmites australis) for load-bearing structural materials

scientific article published in 2023

Paulina is supported by:

About Paulina

Help